Página de Inicio › Forums › HAast (High Availability for Asterisk) › Installation & Upgrade › OEM edition not recovering calls in one queue

Tagged: , , , ,

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • Avatar photoCustomer Inquiry
    Participant
    September 21, 2023 at 7:17 pm
    Post count: 203
    #17561

    We are using the OEM edition of HAast, and have setup the cluster to recover calls, conferences, queues, agents, IVR position, and more.  So far everything is working great, but calls are dropping from one of the queues on failover.

    Queue NIGHTSERVICE might have 20 or more calls waiting in the queue.  If I initiate a failover (from the GUI) then the backup nodes takes over and calls move etc.  Except…just this one queue.  Setup looks fine.  I can send my config files if this helps.

    Avatar photoTelium Support Group
    Participant
    September 21, 2023 at 7:20 pm
    Post count: 265
    #17562

    You actually did very well setting up your system (without any help from Telium).  In fact, if it weren’t for a typo in your NIGHTSERVICE queue recovery parameters everything would have worked.

    Look at the NIGHTSERVICE/queue/rebuildmode key.  You have “orderofarival”.  Notice the missing ‘r’.  It should be “orderofarrival”.  Fix the typo and that queue will work too.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.