Дома Forums HAast (High Availability for Asterisk) Installation & Upgrade Connecting phone sets from subnet different than Management & VoIP NIC subnet

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • Avatar photoCustomer Inquiry
    Participant
    Post count: 203

    We are setting up HAAst and have set the default network to be the “Management NIC” as described in the installation guide. The problem is that we also have external phone sets on public IP addresses.

    How will external phones be able to connect to the cluster if they can’t reach the “VoIP NIC” since the “Management NIC” is the default route?

    Avatar photoTelium Support Group
    Participant
    Post count: 265

    I think you are mixing up some network terms/concepts, but I’ll offer a solution to your problem and some networking concepts along the way.

    First, the reason we recommend placing the gateway on the management subnet is that when a node promotes/demotes the route to the other peer must not change. If the route does change then the PeerLink will drop and both of your nodes may attempt to promote.

    You can safely place the gateway on the VoIP subnet if:

    • the addresses of your management NICs of your two nodes are on the same subnet since they will never make use of the gateway; or
    • you create a permanent route which tells each node how to find the other across the management network.

    So long as you setup your nodes such that management traffic will always go in/out the management NIC then you can configure your gateway/default route however you like.

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.